![background image](http://html1.mh-extra.com/html/winnebago/2014-sightseer/2014-sightseer_operators-manual_987455123.webp)
10-7
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
SLIDEOUT ROOM
TROUBLESHOOTING
(LIPPERT)
-If Equipped
Battery Voltage or Circuit Breaker
Problems
If the slideout room will not work:
•
Turn the Chassis Battery Disconnect switch
OFF and then ON again. This will, in many
cases, reset power to the slideout system.
•
The house battery may be low on charge. Plug
in the external power cord (shoreline), start
the engine, or start up the generator (if
equipped). This may assist slideout room
operation.
•
he chassis battery may be low on charge.
Press and Hold the Battery Boost switch
(located on the dash) while pressing the
interior slideout control switch. This
momentarily connects the house batteries to
assist in slideout room operation.
•
The circuit breaker may be tripped. The
circuit breaker, labeled “Slideout Power” is
located on a panel on an interior wall of the
passenger side storage compartment just
behind or ahead of the entrance door.
Error Codes
When an error occurs during slideout room
operation, the slideout control panel (located in
driver side compartment) will use LED display
lights to indicate where the problem exists.
For specific motor faults, the green LED light
will blink 1 time for Motor 1 and 2 times for
Motor 2. The red LED light will blink from 2 to
9 times, depending on the error code. The error
codes are as follows:
•
(2) - BATTERY DROP OUT.
Battery
capacity low enough to drop below 6 volts
while running.
•
(3) - LOW BATTERY.
Voltage below 8 volts
at start of cycle.
•
(4) - HIGH BATTERY.
Voltage greater than
18 volts.
•
(5) - EXCESSIVE MOTOR CURRENT.
High amperage (also indicated by one side of
slideout room continually stalling).
•
(6) - MOTOR SHORT CIRCUIT.
Motor or
wiring to motor has shorted out.
•
(8) - HALL SIGNAL NOT PRESENT.
Encoder is not providing a signal. This is
usually a wiring problem.
Slideout Room Controller
(Located in a driver or passenger side
compartment, depending on model)
- Remove panel to access
• Status
LED’s
• Motor
Direction
• Mode
Button
• Motor 1
Connection
• Motor 2
Connection