![background image](http://html1.mh-extra.com/html/winnebago/2011-cambria/2011-cambria_owners-manual_987450074.webp)
SECTION 7 –
PLUMBING
7-14
.
3. Remove and save the protective cap from the
end of the antifreeze siphon tube (located
beneath bed - remove side panel to access).
4. Insert the end of the siphon tube into a pail or
container with 2 to 3 gallons of non-toxic RV
antifreeze solution.
5. Turn Winterization valve so that it points
toward the antifreeze siphon tube.
Fill Lines
6. Turn the Water Pump switch ON.
7. Open each hot and cold water faucet handle/
knob in the coach – one at a time each in turn
until antifreeze solution just begins to flow
from the faucet, then close.
Do not forget exterior shower/wash station
knobs (if equipped).
8. Press the toilet flush pedal and hold until
antifreeze begins flowing into the toilet.
Leave small amount of antifreeze that remains
in the bowl.
When Done Adding RV Antifreeze
9. Turn Water Pump switch OFF.
10. Turn the Winterization valve so it points
toward the waterline connected to the water
pump. (This will stop the flow from the
antifreeze siphon tube and revert the tank line
flow to the pump).
Water Heater Bypass Valve Access
(Located within wardrobe - remove
front panel to access)
Water Heater Bypass Valve
(Located behind removable panel in wardrobe
-Typical installation shown
Antifreeze Siphon Tube and Winterization Valve
(Located beneath bed -
remove side panel to access)
Antifreeze Siphon Tube
• Insert into container of RV
water system antifreeze.
Winterization Valve
• Point toward
antifreeze siphon
tube for winterizing.