![background image](http://html1.mh-extra.com/html/winnebago/2011-cambria/2011-cambria_owners-manual_987450039.webp)
4-5
SECTION 4 –
APPLIANCES AND SYSTEMS
To get an accurate reading:
•
Both the chassis engine and the generator
engine must be shut off and 120-volt AC
shoreline unplugged.
•
An interior light should be turned on to
provide a small load which draws off the
battery surface charge.
Water Heater Switches
See Water Heater information elsewhere in
this section for operating instructions.
Water Pump Switch
When use of the self-contained water system
is desired, press the Pump switch (press once to
get to the desired screen, and a second time to
activate or deactivate.) Water will be available as
soon as a faucet is opened.
Refer to
Section 7 - Plumbing
for additional
information on the water pump and initial start-
up.
NOTE: Some models may be equipped with a
Water Pump switch in the water service
center on the outside of the coach or
within the bathroom area for your
convenience.
WATER HEATER - GAS/
ELECTRIC
The Gas/Electric Water Heater has a dual
power feature. It can operate from propane gas or
120-volt house current, or it can use both at the
same time for quicker recovery at times when
you are using a lot of hot water.
See the Water Heater manufacturer’s
operation manual provided in your InfoCase for
complete operating instructions, safety
warnings, and maintenance information before
operating the Water Heater.
Be sure the Water Heater is filled with
water before starting either electric or
propane gas operation.
To fill the Water Heater,
turn the Water Pump switch ON and open a hot
water faucet anywhere in the coach. When water
begins to flow steadily from the faucet, the Water
Heater is full.
For Propane Gas Operation
Press the Water Heater LP switch to ON. The
monitor panel display will indicate that the heater
is “On”. If the monitor panel display reads
“Water Heat LP Fail”, it means that the burner
Battery Levels Switch
LP Gas
Water Heater
Switch
Electric
Water Heater
Switch
Water Pump Switch