6-5
SECTION 6 –
ELECTRICAL
To use the 120-volt Generator, plug the power
cord into the Generator receptacle within the
utility compartment before starting the
Generator.
Generator Basic Operation
NOTE: If the GenSet Start or Stop switch is
momentarily pressed, the monitor panel
will automatically try to start or stop the
Generator. It will try 4 times (10 second
crank, 10 second rest).
To Start the Generator
Press and Hold the GenSet Start button until
you hear the Generator running smoothly, then
release.
To Stop the Generator
Press and Hold the GenSet Stop button until
you hear the Generator come to a full stop, then
release.
Generator Hourmeter
The Generator hourmeter registers the total
number of hours that the Generator has been
operated. Press the GenSet Meter button once to
get reading.
Refer to the hourmeter to determine when
periodic maintenance is due and to record
services which have been performed.
WARNING
Do not plug the power cord into the
generator receptacle while the generator
is running. Electrical shock can cause
personal injury.
Power Cord
Generator
Receptacle
Generator Start/Stop Buttons
(Located on monitor panel)
-Typical View
Generator Hourmeter Button
-Typical View
