M-Series HMI
Chapter 6
Mounting Solutions
M-Series HMI
72
6.2 Safety Precautions
Observe the following common safety precautions before installing any electronic
device:
• Use separate, non-intersecting paths to route power and networking wires. If
power wiring and device wiring paths must be crossed make sure the wires are
perpendicular at the intersection point.
• Keep the wires separated according to the interface. Wires that share similar
electrical characteristics must be bundled together.
• Do not bundle input wiring with output wiring. Keep them separate.
When necessary, it is strongly advised that you label wiring to all devices in the
system.
6.3 Mounting Guide
M-series HMI devices come with different mounting options suitable for most of the
industrial and commercial applications. The main mounting approach is chassis - very
user-friendly in terms of installation. Refer to sub-sections below for more details.
6.3.1 VESA Mount
M-Series HMI comes with VESA mount holes on the rear side. Follow instructions below
to mount the unit with VESA Mount bracket (not supplied by Winmate).
VESA Plate Dimensions
Screw Hole Diameter
Compatibility
75 x 75 mm
VESA M4 x 5 mm
Swing arms mounting kits
*
with customer’
s bracket
