Step 2: Teaching
Now put the wireless contact FM.A into the
teaching mode. To this effect press the
teaching
button
by
means
of
a
straightened paper clip.
Now the wireless contact FM.A has been
taught in.
The wireless contact FM.A supports the
following Equipment Profile (EEP):
D5-00-01 (1BS telegram)
This radio telegram transmits the states:
open/ closed.
Installation
The wireless contact is suited for
installation into windows and doors made
of PVC-U, timber or aluminium. The
following section describes the installation
of a radio contact into a turn-tilt window.
Installation into a door is performed in the
same way.
Step 1: Choose mounting place
The perfect place for attaching the radio
contact is at the upper area of the
window’s drive side. In this position the tilt
as well as the turn position of the sash is
indicated as “open” (see positioning area 1
in the illustration below).
If the tilt position of the window is not
indicated as “open” but “closed”, the radio
contact should be installed in a horizontal
position at the bottom (see positioning
area 2).
Please note:
Please observe that the indicated areas
are not suitable for installation of the radio
contact FM.A because either the opening
of the window may cause damage of the
radio contact FM.A or the detection of the
window’s opening may be very unprecise.
Step 2: Mounting the wireless contact and
magnet
The installation position of the magnet and
the radio contact FM.A may vary according
to the window model. The following
illustration
shows
basic
installation
positions with the help of the example of
the upper window corner at the handle
side.
Teaching
button
1
2
