Mounting: Step 1
Mounting: Step 2
Click!
Commissioning/Mounting:
The motor unit, electronics and display unit are not connected to one another
upon shipping. Please conduct steps 1 and 2 in sequence in order to obtain
a functional unit. After completing a function check, disconnect the display
unit (Fig. 2) from the system again in order to enable trouble-free installation
of the system in the furniture.
1. Plug electronics housing and motor unit together until they click into place.
2. Insert the display unit plug into the electronics bushing in the correct position.
3. Check components to make sure they are seated firmly.
If it is not possible to install the motor unit and electronics in
combination for space reasons (for instance), an optionally
available connection cable between the motor unit and the
electronics can be used.
Changing batteries:
Place the batteries into the electronic control unit before installing the system.
1. Loosen screw. Open battery compartment lid.
2. Insert/change batteries.
3. Close battery compartment lid. Screw in fastening screw.
Installation instructions:
This M33 is a motorised lock with three-point locking. This means that three
deadbolts extend from the housing simultaneously. Rods are generally con-
nected to both lateral sliding bolts. This makes it possible to relocate the
locking points (see installation diagram). The accessories required are part
of the set package. Please use the length calculation in the diagram to deter-
mine the rod lengths. The illustration is based on the example of a revolving
door for furniture.
S
at
ng
e
lnä
gn
e=
B-
35
ba
r
eln
g
ht
=B
5-
3
S
at
ng
ne
l
nä
ge
=A
5-
3
ab
rl
ne
tgh
=A
-5
3
A
B
Li
ch
t
se
nI
ne
nm
aß
/
nI
et
nr
la
he
gih
t
76
74
70
70
21
21
Rod length calculation: All specifications in mm
