WINEMASTER SP40CAPRO, Инструкция по установке и эксплуатации

Страница: 10 / 16

INSTALLATION AND USER MANUAL
3.3.
Installation of the inside unit
Due to the diversity of installations and the type of locations, each installer must adapt to the constraints
of its installation.
3.4.
Ducting connection
THE PIPE CONNECTION
Both units are loaded with an inert gas (nitrogen). Connect the 2 units
line and 3/8" for the gas line. The nuts are provided. Put them on the copper rigid pipe before performing
the extender.
The maximum length is of 20 m,
the
must not exceed 10 .
Lenghts
0-5 m
5 to 10 m
10 to 15 m
15 to 20 m
When all is working properly, before disconnecting the
Disconnect then the pipes and replace
SUCTION
MANUAL WINESP40CAPRO
Installation of the inside unit
and the type of locations, each installer must adapt to the constraints
-
Provide openings
suction and blowing
- Provide space for
electrical connections and
the condensate drain
-
The suction and blowing
be even partially
-
The blowing and suction should be
separated to avoid a resumption of the air
supply, even partia
suction temperature should be the same
as the room temperature when the unit
produced cold)
THE PIPE CONNECTION HAS TO BE UNDERTAKEN BY A PROFESSIONNAL
gas (nitrogen). Connect the 2 units by a copper line 1/4" for the
line. The nuts are provided. Put them on the copper rigid pipe before performing
maximum elevation is 10 meters. The number of bends
Gas loading (R404A)
900 g
1000 g
1100 g
1200 g
before disconnecting the pipes, unscrew fully the valves
replace the gaps on the valves.
BLOWING
Page 11
and the type of locations, each installer must adapt to the constraints
openings on the bottom for
and blowing
space for refrigeration and
electrical connections and the passage of
condensate drain
and blowing should in no way
even partially obstructed
The blowing and suction should be
separated to avoid a resumption of the air
even partially (for checking, the
ture should be the same
as the room temperature when the unit
BY A PROFESSIONNAL.
by a copper line 1/4" for the liquid
line. The nuts are provided. Put them on the copper rigid pipe before performing
The number of bends per link
, unscrew fully the valves.