P a g e
|
31
The RECEIVE SIGNAL screen allows for manual jogging of the antenna for
assembly, wiring and even pointing purposes used in testing. However, if in
Generic mode, please note that after movements are accomplished in this screen
the only choice available is to tap on the “NEXT” button which will then require
that the system is stowed.
If the system is already configured on any mode except Generic, the “MAIN”
button will be available to exit the manual movement screen back to the main
menu without changes to you jogging movements being nulled.
The step rates available here are .1, .5, 1, 5, 10, 25 and 45 degrees per button
selection. Signal Strength is also displayed here for pointing purposes.
5.
EMERGENCY screen -
If you have selected “NO” on the ANTENNA SETUP screen then you will move
forward to the EMERGENCY movement screen. This screen asks if you want to
perform emergency movement of the motors for stowing purposes. It is not
necessary to perform emergency motor movement to configure the controller.
a)
If you select “NO” you will be taken to the CALIBRATION screen on item 6.
b)
If you select “YES” the following screen will appear:
Содержание WX980
