6
P-clamp installed 15”
from ends of sheathed
cables, next to zip tie on
sheathed cables
Bolts holding
LNB guard
to feed arm
Feed arm
Screws holding
LNB to feed arm
Front of
LNB guard
13. Place the p-clamp on the sheathed
cables, and make sure the hole in
the p-clamp is positioned above
the cables. The p-clamp must be
15
inches
from the ends of the
sheathed cables. This point on the
cable may already be marked by a
zip tie, mark, or tape.
14. Align the hole in the p-clamp
with the hole in the lift arm.
Install the screw through the
p-clamp and lift arm, and tighten.
Model RP-SK49 DIRECTV SWM Slimline Repl. Cable
1. Remove and set aside the four
nuts and bolts holding the LNB
guard to the feed arm. Then, slide
the LNB guard down the feed arm
and toward the reflector.
2. Remove and set aside the two
screws holding the LNB to the
feed arm.
3. Carefully slide the LNB out from the
feed arm. Disconnect the coax cable
from the LNB using a
7
/
16
” wrench.
4. Using a
7
/
16
” wrench, disconnect the
cable from port C on the top of the turret.
5. Using a
5
/
16
″
wrench, remove the screw holding the p-clamp to the
lift arm, and detach the p-clamp from the lift arm. Set the screw and
p-clamp aside; you will need these later.
6. Once disconnected, remove the sheathed cable.
7. Run the replacement sheathed cable through the feed arm.
8. Connect the coax cable running through the feed arm to the LNB.
Tighten the cable until fingertight, and then use a
7
/
16
” wrench to
tighten a quarter turn more.