Align the four holes on the inside of the reflector bracket with the four marked
holes in the adaptor plate. See image below for the holes to align with the
reflector bracket and adaptor plate. The numbers on the reflector bracket and
adaptor plate should match.
TIP
The bracket should be installed so that the LNB arm
assembly is at the bottom of this plate.
Replace the supplied
3
/
16
inch Allen screws through these
four holes, and tighten.
After the bracket has been installed, connect and tighten the
coaxial cables. These can be re-connected in any order, but
port D should be left open.
Install the provided F-cap on port D. The F-cap will not be
used if converting from a SWM TRAV’LER antenna.
Find the cable tie on the coax cables that you just connected to the mount.
Place the coax cable clamp on the cables just above this cable tie. Carefully
screw this coax cable to the lift arm using the
5
/
16
inch screw provided.
Be careful not to strip out the hole for the
5
/
16
inch screws when you replace
the clamp holding the coax cables to the arm. Do not use a power tool.
NOTE
If the cable tie is missing, install the clamp fourteen inches from the end
of the connectors.
Align the four outer holes in the reflector bracket with the four corresponding
holes in the reflector. Install a bolt through each hole on the front of the reflector,
and install a nut on each bolt. Tighten.
Use the provided packaging to re-package the removed LNB and attached cables.
If you are an RP-SK21 user, see
Re-packaging the Removed LNB for RP-SK21 Users
.
If you are an OE-DISH user, see
Re-packaging the Removed LNB for OE-DISH Users
.
1
2
3
4
F-cap
5
6
7
1
1
2
3
4
2
3
4
1
2
3
4
