If converting a DIRECTV SWM Slimline antenna to a DISH TRAV’LER antenna, remove
the power inserter and SWM splitter; these will not be used.
Remove the four reflector nuts and bolts, and remove the dish. Set the nuts and
bolts aside.
Disconnect the coaxial cables from the turret. Note that the D port will not be
present on a SWM TRAV’LER antenna.
Remove the bolt holding the cable harness to the unit, and detach the cable
harness from the lift arm.
Set the bolt aside; you will need this later.
NOTE
If you are replacing an existing Reflector and Assembly,
follow the instructions
below, otherwise proceed to “Installing the DISH Reflector and LNB Assembly” section.
Removing the Reflector and LNB Assembly
Reflector nut not shown
1
2
Turret
4
5
Bolt
Cable
clamp
Lift
Arm
Cable
harness
3
