Winegard Shaw Direct SK-7002, Руководство по установке

Страница: 4 / 12

NOTE: Anything in the striped area will interfere with the operation of the TRAV’LER antenna
and may cause damage to the object or the TRAV’LER antenna.
TRAV’LER Mount Installation
Verify that the “FRONT” of the transition plate is facing the front of the vehicle, then place the
TRAV’LER antenna mount on the roof where you plan to install it. See Figure 3. Mark where the screw
holes will go by placing marks through the holes in the mount base on the roof of the RV. It is impor-
tant that you be able to see these marks!
Move the TRAV’LER mount out of the installation area. It is
recommended that you don’t pre-drill the holes at this time.
Use a solid bead of sealant to connect these marks in the shape of the base.
Replace the TRAV’LER antenna base and screw it to the roof. Check with your vehicle manufacturer for
any special screw requirements before using the supplied screws.
3. The unit must be within 5° of level for best operation.
4. Make sure that the location offers enough support to attach the TRAV’LER antenna securely.
5. Find a well ventilated location with a 110 V outlet for the TRAV’LER Interface inside the vehicle.
Make sure to clean the installation area before you begin.
You will want to decide where the wires will enter the vehicle. One coax cable per receiver and a control
cable will need to be run into the vehicle.
Warning: Do not run the wires through the striped area shown. Consult your receiver
manual for specifics in the diagram.
FIGURE 3
4
!
INSTALLATION
FRONT OF R
V
TRANSITION
PLATE
FRONT
SCREW
HOLES
24 inches
18 inches