3
2. Determine which programming you will be using. This will determine how you set your switches.
For
DISH Network
set switches to
119°
. For
ExpressVu
®
,
set switches to
091°
.
NOTICE!
This model is PRESET for DIRECTV
®
receivers
Mounting Option A.
If you have a DISH Network
®
or ExpressVu
®
(Canada) receiver, or
you choose Mounting Option B, you must change the numbered
switches inside the dome.
TO CHANGE SWITCHES INSIDE DOME —
1. Remove screws holding dome to base and remove dome. Place dome in safe spot to avoid damage.
Switches will be set at
101°
for
DIRECTV
®
. You will be changing these switches.
DIRECTV
®
receivers must be set to the two satellite, oval dish setting. Refer to your receiver manual.
DISH Network
®
receivers must either have the check switch set for SW42 or unknown, no satellite found.
See page 5.
The satellite system has two modes of operation;
Tracking Mode
and
Sleep Mode.
When you first turn the
unit on it enters
Tracking Mode
.
(The unit will not toggle in Tracking Mode, see page 5.)
In this mode,
the unit will search and actively follow the satellite as the vehicle travels. Tracking Mode ends when the unit
has successfully finished its search and the vehicle has not moved for six minutes.
Sleep Mode
is the unit at rest mode. During Sleep mode the dish will toggle between primary and second-
ary satellites as you change channels with the remote. The unit enters Sleep mode about six minutes after
a successful search if stationary, or six minutes after the vehicle stops moving. (See page 5.)
(#1 represents Switch DOWN; #0 represents Switch up)
Sat. Rcvr. Mt. Option Switch Set Position
...................................
1 2 3 4 5 6 7 8
DIRECTV
A
0 0 0 0 0 0 0 1
(FACTORY PRESET)
DIRECTV
B
1 0 0 0 0 0 0 1
DISH NETWORK A
0 0
0 1 0 0 1 1
DISH NETWORK B
1 0 0 1 0 0 1 1
ExpressVu
A
0 1 0 1 1 0 1 1
ExpressVu
B
1 1 0 1 1 0 1 1
Quick Reference Guide
1 2 3 4 5 6 7 8
MOUNTING OPTIONS
SHOWN BELOW
MOUNTING
OPTION A
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
MOUNTING
OPTION A
MOUNTING
OPTION A
1= DOWN
0= UP
1= DOWN
FIGURE 1A, OPTION A
CENTER LINE OF VEHICLE
REAR BASE FOOT
(MUST BE PARALLEL
TO CENTER LINE)
MV-3500
BACK OF VEHICLE
FRONT OF VEHICLE
FIGURE 1B, OPTION B
MOUNTING OPTIONS A AND B
CENTER LINE OF VEHICLE
REAR BASE FOOT
(MUST BE PARALLEL
TO CENTER LINE)
MV-4005
BACK OF VEHICLE
FRONT OF VEHICLE
MV-4005
0= UP 1= DOWN
0= UP
1= DOWN
0= UP
0 0 0 0 0 0 0
1
0 0 0
1
0 0
1
1
0
1
0
1
1
0
1
1
