8
3. Using the Wine C50 IN
C50IN must be installed by complying with the national rules of electric installation.
3.1 Connecting the air-conditioner
Connect the male plug to a 230V / 16A power socket. Switch on the air-conditioner by
pressing button 1 on the diagram below. The fan on the cellar side comes on immediately.
The compressor may not come on until 2 minutes later if the temperature in the cellar is
higher than the set temperature. If the cellar temperature matches the thermostat setting,
the compressor will not come on.
If you want to reduce the setting quicker, you can press button 2 on position II. I this case,
the speed of air circulation increase and the wine cellar will reach nominal power.
For the cellars where the volume is higher than 20m
3
(this volume could change according
the insulation condition). It is advisable, specialy during heat period, to always remain with
position II.
3.2 Control panel
The air-conditioner is equipped with an electronic
thermostat fitted to the front of the device so
that the operating status of the WINEMASTER can
be seen at any time from inside the cellar.
The thermostat permanently displays the
temperature of the air in the cellar which varies
in range of 2 °C. The variation of the air
temperature carries a smaller variation than the
wine’s one due to the thermal inertia of the
liquid.
The thermostat as been set by factory at 12°C.
When you start the cellar wine, you should verify
and, if need, modify the temperature following
instructions below.
The on/off button IOII (reference 1 in diagram)
allows you to start the air conditioner and select
the level of ventilation within the cellar.
The button IO (reference 2) when lit up in green
indicates the electricity connection of the unit and
allows you to illuminate the integrated flourescent lamp.
The setting of the targeted temperature of the cellar is made on the thermostat
Use the following process:
Press the button
for one second until the message o1 appears.
Press then the button
- the set temperature of the cellar will appear.
Use again the
button to increase the temperature or the
button to lower the
temperature. When the right temperature is set, press the
button to confirm it.
WC50IN installation guide:Layout 1
23/4/08
12:51 Page 8
