Windsor 1.005-297.0, Руководство оператора

Страница: 17 / 32

16
Maintenance
Cleaning the Machine
Clean the machine with a soft cloth and a neutral pH cleaner.
With scrub head resting in the vertical position, rinse bearing while rotating the pad driver or brush. Before emptying
the solution tank, adjust the handle to the middle position so that the water drains behind the machine.
Changing The Driver Grip Face
Remove the ten outer screws that fasten the grip face disc on the driver plate. To save time, use an electric
screwdriver with a #3 Phillips Head bit.
The Number #3 Phillips head bit is slightly larger than standard size. It is important that you are using a #3 Phillips
Head bit, as smaller bits can damage the screw heads and produce sharp edges which can damage the cleaning
pads. Attach a new grip face disc to the driver plate using the ten screws.
Make sure that the screws are very tight, not loose. If the screws are even slightly loose it can cause damage to the
grip face disc. Ensure that the four holes in the middle of the grip face disc are aligned with the screws located on
the driver plate. An exact alignment allows easy removal and installation of the driver plate.
8.638-856.0 Manual Operators - Radiant Orbital Scrubber