GENERAL CARE & CLEANING OF VINYL UPHOLSTERY
Remove hair & body oils
; Your recliner should be cleaned
with mild soap & water solution and a
damp cloth on a regular basis (especially where skin & hair make contact with upholstery). Avoid
harsh detergents or chemicals that could damage the upholstery or finish of your recliner. If the
recliner is disenfected, the chair MUST be wiped off with ONLY clean water on a damp cloth.
Note: Disinfectants alone, will not provide adequate "grease or oil cutting" properties to remove hair
& skin oils. Over time, the appearance and feel of your upholstery may diminish if not cleaned
properly.
Please refer to the
PERMA
BLOK
instruction tag that is attached to your Care Cliner for complete
care and cleaning instructions.
Retain information on tag for future use
.
FOR FURTHER CLEANING INFORMATION VISIT:
http://www.wincomfg.com/permablok-info-and-cleaning-instructions
MAINTENANCE GUIDE
Swing-leg Gas Spring Replacement
1. Fully elevate the legrests for easier access to
the gas springs.
(FIG.24)
2. Remove the swing-leg release handle by
unscrewing the hex-head bolt.
(FIG.24)
3. Locate the 2 gas springs positioned above the
Monarch Power Unit
4. Remove
(A)
the front mounting pin and spacers
first and then
(B)
the rear mounting pin and
spacers. Keep for re-use.
(FIG.25)
5. Discard old gas spring
6. Attach the front of the new gas spring using
original pin and spacers
7. Attach the rear of the new gas spring WITHOUT
any spacers.
8. Make sure the legrest with the new gas spring
is level with the opposite legrest.
•If the new gas spring requires adjustment,
remove the rear pin and adjust.
•Turn the casting LEFT to raise and RIGHT to
lower.
9. After adjustment is complete, attach the rear of
the gas spring with BOTH pin and spacers.
10. Re-attach the swing-leg release handle.
(FIG.24)
FIG. 24
FIG. 25
17
