15
OPM-137/D
2. Remove oil level check plug.
3. Remove the oil drain plug, drain the oil into a clean
oil resistant container, 1 quart or larger. Check the oil for
metal. Fine metal dust in the oil does not indicate trouble,
but metal chips do. Dismantle the gearcase and look for
damaged gears if you find metal chips in the oil.
4. Replace the oil drain plug. Refill the gearcase through
the breather port with new oil of the recommended type.
Fill the case until a little bit of oil comes out of oil level
check plug hole (it will take less than 1 pint when dry).
5. Replace the oil level check plug.
6. Replace the breather.
CLEANING & INSPECTION
Use a vacuum cleaner or dry low pressure compressed air
(regulated at 25-35 PSI) to clean the generator periodically.
WARNING:
Do NOT clean the generator while it is running.
Proceed as follows:
1. Remove control box cover. Vacuum or blow dust or
debris from the control box. Inspect all wiring for correct
routing, fraying insulation, and secure connections.
2. Remove end cover. Vacuum or blow dust and debris
from the inside of the generator. Inspect wiring for loose
connections, fraying insulation and correct wire routing.
3. Replace end cover and control box cover.
GENERATOR STORAGE
Before storing the generator, apply a heavy coat of grease
to the splined input shaft. Store the generator in a sheltered
area, where it is protected against snow, rain, and excessive
dust.
0" --
1
Oil Level Plug
