7
OPM-136/D
INSTALLATION
FOUNDATION MOUNTING
Mount the generator on a foundation if it is to be used as
a permanent or standby power source. When planning a
foundation consider the following points:
A. The foundation location should enable aligning the drive
shaft (tumbling bar) in a straight or nearly straight line
between the power take-off and the generator input
shaft. Misalignment must be less than 5 degrees during
generator operation, even though the mechanical design
of the tumbling bar would allow greater misalignment.
B. The foundation must be solid enough to absorb
generator starting and reflected load torque during
operation.
C. The foundation surface should be flat.
D. Space is required around the generator for mounting
switching devices, making connections, and for servicing.
E. For dimensions needed for install for your specific
generator, please refer to it’s outline drawing. The
hardware needed is dependent on your distinct
application.
F. The generator mounting bracket must rest evenly and
firmly on the foundation. Install shims if necessary to even
out the foundation under the mounting pads then bolt
the generator firmly in place.
TRAILER MOUNTING
Optional
Mount the generator on a trailer if you plan to use it as a
portable power source. When selecting or building a trailer
to mount the generator, consider the following points:
A. The trailer construction must be strong enough to
support the generator.
B. The design of the trailer must enable the trailer to remain
stable during operation, and to resist tipping caused by
generator starting and reflected load torque.
C. The trailer height and mounting position of the
generator on the trailer should enable aligning the drive
shaft (tumbling bar) in a straight or nearly straight line
between the power take-off and generator input shafts.
Misalignment must be less than 5 degrees during
generator operation, even though the mechanical design
of the tumbling bar would allow greater misalignment.
D. The generator mounting area of the trailer bed should
be flat.
The frame pads must rest firmly on the trailer bed. Install
shims if necessary to even out the bed under the mounting
pads, then bolt the generator firmly in place.
WARNING: Personal Injury & Equipment Damage
Trailer may tip over and cause injuries if wheels are not
spaced far enough apart.
THREE-POINT HITCH KIT
Optional
WARNING: PERSONAL INJURY & EQUIPMENT
DAMAGE
When using the 3-point hitch assembly all three points
must be attached to the tractor. Failure to do so will cause
the generator to tip when lifting it, damaging both the
t-bar and the generator.
A. The three point hitch must be attached to the tractor at
all times during operation.
B. When operating the generator the three point hitch and
generator must be sitting on flat level ground. All four
deck pads must be in constant contact with the ground
at all times. This will reduce the vibration in both the
generator and the tumbling bar.
C. For safety the generator must be bolted to the three
point hitch deck using all four mounting bolts.
