© by WilTec Wildanger Technik GmbH
Seite 4
http://www.wiltec.info
Resistance
As for the continuous operation, the maximum temperature of the liquid to be transported should not
35°C.
This pump must not be used to transport any combustible, gasing or explosive liquids.
Electrical connection
The electrical connection is made to a grounded socket 230 volts – 50 Hz protection at least 10
amperes.
The device is switched on and off by using the built-in ON / OFF switch. When the engine is
turned on, the control lamp in the interior of the switch lights up.
By a built-in thermal protection the engine is protected against overloading or blocking . In case of
overheating the pump is switched off automatically by the protection. After cooling down the
pump again switches on automatically .
Mains connection
Your pond pump is already equipped with a grounded plug. The pump is meant to be for a connection
to a grounded socket with 230 volts – 50 Hz. Make sure that the socket is sufficiently secured ( at least
6A) and in a good condition. Run the pump plug into the socket. The pump is ready for operation.
Never operate the pump if the cord or the plug is damaged.
Please make sure that the connection to the power source is installed in a way that prevents water to
flow along the cable to the power plug´ s direction. The installation should be similar to the below men-
tioned picture. The upward arc prevents that water drops from getting into the socket.
Types´ Data
model
voltage
power consumption delivery head
pump
performance
weight
HJ-502
230
6W
0,9m
500l/h
0,3kg
HJ-602
230
8W
1,3m
600l/h
0,44kg
HJ-902
230
16W
1,5m
900l/h
0,6kg