WilTec 61811, Руководство по эксплуатации

Страница: 6 / 11

© by WilTec Wildanger Technik GmbH Item 61811 Page 6
http://www.WilTec.de
http://www.aoyue.eu 11 2021 -1
http://www.teichtip.de
Assembly
Step 1
1. The distance between the floor and the
rail middle line is 43 mm + door
10 mm. With a pencil, draw this line on
the wall above the doorway, making
sure that it is level.
2. Check that your floor is level. If not,
measure the correct distance from the
highest point of the floor.
3. Make sure that the line that you have
drawn has the same length as the rail.
This makes it easier for you to find the
centre of the rail holes so that you can
then attach the rail to the wall.
Step 2
1. Now hold the rail so that the line drawn
on the wall in step 1 is visible through the
rail holes.
2. Mark the drilling point in the middle of
each rail hole.
3. Set the rail aside.
4. Using a 12 mm bit, drill the holes for the
rail at the markings. You do not need to
drill holes if the wall is made of wood.
Step 3
1. Put a door stop on the end of the rail; but
do not screw it tight until later with the
Allen key (see below).
2. Loosely attach one end of the rail to the
wall.