3
4
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Hours: 7 am to 6 pm MST.
Warning:
The Outside Antenna must
be installed on an outdoor
permanent structure with a
separation of at least 20 feet
from all persons during
normal operation.
!
Cell Tower
RF Signal
Yagi External Antenna
Warning:
Never point the front of the Yagi Antenna
toward the Inside Antenna - oscillation will
result, causing amber light and gain reduction.
!
NOT
CORRECT
CORRECT
Pointing toward
cell tower
Lightning
Surge Protector
(sold separately)
Signal Booster
Surge Protector
Power Strip recommended for all AC power supplies
To Outside
Antenna
Ground Wire
(not included)
To Inside
Antenna
Select a location on the roof of the building to install the Outside Antenna. Take extreme
care to ensure neither you nor the antenna come in contact with any electrical power lines.
Using a cell phone in test mode to find the strongest signal from the cell tower. For test
mode help, visit
www.WilsonElectronics.com
or call Technical Support at 866-294-1660.
Follow the specific antenna installation instructions included with the Outside Antenna.
A Yagi Antenna must be installed horizontally with the elements vertical and the drip hole on
the bottom. Ensure there is three feet of clearance in all directions surrounding the antenna.
Installing a Wilson Electronics Outside Antenna
Installing Lightning Protection
(sold separately)
Install the Lightning Surge Protector (LSP) close
to the Signal Booster. Attach the cable from the
Outside Antenna to the surge protector, using a
short length of low loss cable; attach one end to
the LSP and the other to the Outside Antenna
connector on the Signal Booster.
Ensure
the LSP is properly grounded.
LSP may be
purchased at
www.WilsonElectronics.com
or
call 800-204-4104 (part #859902).
