6
Warnings And Recommendations
Warning:
Do not plug in the power supply until the outside antenna cable is attached to the
signal booster .
Warning:
RF Safety:
The iBooster cradle/signal booster must be installed with a
separation of at least 8 inches from all persons and must not be located in
conjunction with any other antenna or signal booster .
Warning:
RF Safety:
The outside antenna must be installed with a separation of at least
8 inches from any of the vehicle’s occupants or nearby persons and must not be
located or operating in conjunction with any other antenna or signal booster .
Separation of inside and outside antennas is very important. In a vehicle, the metal roof acts
as a barrier and helps shield the two antennas from each other, preventing oscillation.
If the vehicle has a sunroof, it is important to keep the outside antenna at least 8 inches from the edge
of the sunroof . This prevents the signal booster from oscillating .
About Wilson Electronics
Wilson Electronics, Inc . has been a leader in the wireless communications industry for over 40
years . The company designs and manufactures signal boosters, antennas and related components
that significantly improve cellular telephone signal reception and transmission in a wide variety of
applications, both mobile and in-building .
With extensive experience in antenna and signal booster research and design, the company’s
engineering team uses a state-of-the-art testing laboratory, including an anechoic chamber and
network analyzers, to fine-tune antenna designs and performance . For its signal boosters, Wilson
Electronics uses a double-shielded RF enclosure and cell tower simulators for compliance testing .
Wilson Electronics signal boosters feature patented Smart Technology ™ that enables them to
automatically adjust their power based on cell tower requirements . By detecting and preventing
oscillation (feedback), signal overload and interference with other users, these Smart Technology ™
signal boosters improve network cell phone areas without compromising carrier systems .
All products are engineered and assembled in the company’s 55,000-square-foot headquarters in St .
George, Utah . Wilson Electronics has product dealers in all 50 states
as well as in countries all over the world .
SYMPTOM: Red Light always ON
Make sure that the antenna connector is on tightly .
1 .
Place the Outside Antenna on its side (see picture) . Reset
2 .
iBooster power (off and back on again) . The light should
now be green (antenna was too close) . Turn iBooster off and
proceed to step 3 .
Return the outside antenna to its upright position, and
3 .
move it further towards the rear of the vehicle, (away from the iBooster) but no closer than 8
inches from a sunroof, rear or side windows . Power iBooster back on and recheck for a green
light . If light is still red, continue moving the antenna further back and resetting the power until
the light changes to green and stays green . Remember to stay more than 8 inches away from a
sunroof, rear or side windows .
If none of the above corrects the problem, call Wilson Electronics Technical Support at 866-294-1660 .
4 .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected] Hours: 7 am to 6 pm MST.
