4
OPTION 1
Air Vent Bracket
1 . Slide the bracket clips into
the chosen vent location
until they snap into place . If
necessary, use a thin-bladed
screwdriver to gently pry the
clips apart as they slide into
the vent .
2 . Position the moveable arm
at the base of the bracket to
achieve the desired angle
and to provide additional
stability for the iBooster .
OPTION 2
Adhesive Bracket
1 . Clean the area where the bracket is
to be mounted with rubbing alcohol
and a soft cloth . Allow to dry .
2 . Peel the backing to expose the
adhesive and press the bracket onto
the desired location in the vehicle .
Note: be sure the tab is positioned
vertically,
not horizontally.
3 . Allow the adhesive to cure for
24 hours before you attach the
iBooster .
4 . Once the cradle is attached, you
can adjust the angle of the adhesive
bracket by applying gentle pressure
to the top or bottom of the iBooster .
Lock bracket into position with a
phillips head screwdriver once
desired angle is established .
OPTION 3
Adhesive/Screw Swivel Bracket
This mount allows for adhesive
mounting as well as more permanent
screw mounting . This option
is designed to swivel when the
knurled nut is loosened, for greater
adjustability of the iBooster viewing
angle . For adhesive mounting, follow
steps 1, 2 and 3 of Option 2 .
For screw mounting
, use an ice
pick or an awl to punch through
the adhesive and expose the four
screw holes in the bracket . You must
provide the screws of an appropriate
size for your particular application .
Using the bracket as a template,
mark the locations for the screws as
shown, drill pilot holes, attach the
bracket with adhesive, and tighten
all screws .
3. Attach the iBooster
®
Once you have installed your selected mount in the desired location, attach the cradle by aligning the
rectangular hole on its back with the tab on the mount . Grasping the sides of the cradle, slide it downward
approximately ¼ inch into place .
2. Attach the Mounting Bracket
Three different mounting brackets are provided for attaching the iBooster to your vehicle’s dash .
Choose the appropriate one for your application . See bracket specific mounting options below .
4. Powering up the Wilson Electronics iBooster
®
Signal Booster
Make sure the outside antenna cable is connected before powering up the signal booster.
Connect the mini-USB plug on the power cable to the signal booster’s mini USB port on the iBooster .
Insert the adapter into the vehicle power adapter outlet of your vehicle .
The signal booster may remain on all the time . However, leaving the signal booster on in a vehicle
when it is not running can discharge the battery in a day or two .
A good option is to power the signal booster through the ignition switch so that the signal booster
is turned on and off with the vehicle . The 12 volt AC socket on many vehicles is shut off with the
ignition key .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected] Hours: 7 am to 6 pm MST.
