WILSON AUDIO Sasha DAW, Руководство по установке и эксплуатации

Страница: 17 / 27

S
e c t i o n
3 .1 – S
P i k i n g t h e
S
A S h A
DAW
33
W i l s o n A u d i o S p e c i a l t i e s
32
Sa sha DAW I n stal l ation and Car e G u ide
Section 3.1 – Spiking the Sasha DAW
Your dealer is trained in the art and science of the Wilson Audio Setup
Procedure ( WASP) outlined in Section 1.2. Before the spike/diode assemblies
are attached to the bottom of Sasha DAW, the set up and fine tuning of your
loudspeaker should be completed. Before spiking Sasha DAW, use masking tape
to carefully mark their location.
Woofer Module Spikes
Included with Sasha DAW are two sets of Woofer Module spikes, which
provide acoustical isolation as well as optimal height placement for your speak-
ers. There are two ways of assembling the spikes (with or without the diode).
Your choice will depend on your listening room and personal tastes.
Spike/Diode Assembly
1. Locate the spike assembly. On the spike, move the nut to
about two threads from the point. This will allow for greater
movement when leveling the loudspeaker system.
2. Screw the spikes into the diode until the nut is against the di-
ode. Be careful that the nut does not turn while inserting and
threading spikes into the diode.
Note: Do not tighten these assembled spikes. You will need to unscrew
A u t h e n t i c E x c e l l e n c e ™
them when you level the Sasha DAW. This will ensure that if for any reason
you have to remove Sasha DAW spikes, you will be able to withdraw the set
screw using the supplied Allen wrench.
3. Screw the all-thread set screw into the diode until it meets the
spike for your system. Make sure the allen head portion of the
all-thread faces towared the spike.
4. Assemble the rest of the spikes/diode.
Spike Installation Procedure
5. Remove the Upper Module from the Woofer Module.
6. Carefully lay the Woofer Module on its side.
7. Insert the spike/diode assemblies into the four holes located
on the bottom of each Woofer Module. Tighten until the top
surface of the Woofer Module Spike (or spacer) touches the
bottom surface of the “X” material plate.
Note: The spike receptacles are tapped directly into the “X” material
plate on the bottom of the Woofer Module. Be very careful NOT TO CROSS
THREAD the spikes.
S
pike
d
iode
a
ll
t
Hread