WILSON AUDIO Sasha DAW, Руководство по установке и эксплуатации

Страница: 13 / 27

S
e c t i o n
2 . 3 — i
n i t i A l
A
S S e m b ly
25
W i l s o n A u d i o S p e c i a l t i e s
24
Sa sha DAW I n stal l ation and Car e G u ide
Section 2.3—Initial Assembly
Preparation
You will need the following items:
• Supplied hardware kit
• Tape measure
• Propagation Delay Correction Tables (Section 5).
• Known listening position
• Masking Tape
Take a moment to familiarize yourself with the top of the tables con-
tained in Section 5. There are two tables, which contain important information
on the Sasha DAW’s adjustable Propagation Correction, that will be needed
during the setup.
Upper Module Assembly
The Upper Module uses the combination of three spikes installed into the
bottom of its enclosure. The spikes provide proper coupling of the Upper Mod-
ule to the Woofer Module and are used to correct propagation delay. “AA” spikes
are always installed in the front two positions (the threaded holes located near
A u t h e n t i c E x c e l l e n c e ™
the bottom front of the enclosure). The spike-type is stamped in the round top
of the spike. These two spikes screw into the Upper Module as shown to the left.
The spikes should be screwed in all the way, until they are hand tight. Do not
over tighten spikes.
Alignment Procedure
Locate the Alignment tables in Section 5. These tables contain critical
information that will guide you to position the Upper Module for optimized
propagation delay adjustment.
The rear of the Sasha DAW Upper Module assembly rests on a specific step
in the Alignment Block. The position of the Upper Module is facilitated by the
Alignment Block steps. The position is designated by the engraved numbers in
the Alignment Block mounting plate. There are also four spike configurations,
the use of which are determined by the distance/ear relationship of the installa-
tion. The three configurations are: no spike, a number 1, 2, 3, or 4 spike. The ta-
ble in Section 5 contains information on the appropriate length spike to be used
in the rear of the Upper Module. Propagation Delay Tables are also available on
the Wilson Audio APP, which is available on iTunes and Android Marketplace.
Determine the alignment of each Upper Module as follows:
1. Repeat each step of this procedure on the left and right chan-
nels simultaneously.
U
pper
M
odUle
S
pike
p
laceMent
G
Uide
S
tepped
p
ropaGation
B
lock
p
ainted
i
nner
e
dGe and top
of
W
oofer
M
odUle