Wilo 2.0-VE 22-36-52, Инструкция по установке и эксплуатации

Страница: 16 / 28

en Description and function
16 WILO SE 02/2022
6 Description and function
6.1 Product description
Fig. 1
1. Motor connection bolt
2. Coupling gard
3. Mechanical seal
4. Hydraulic stage casing
5. Impeller
6. Pump shaft
7. Motor
8. Coupling
9. Lantern
10. Tuble liner
11. Flange
12. Pump housing
13. Base plate
Fig. 2, 3
1. Strainer
2. Pump suction valve
3. Pump discharge valve
4. Check valve
5. Drain + priming plug
6. Air bleed screw + Filling plug
7. Tank
8. Foundation block
9. In option: pressure plugs (a-suction, b-discharge)
10. Lifting hook
6.2 Design of product
ƒ
Helix pumps are vertical high pressure non-self priming pumps with inline connec-
tion based on multistage design.
ƒ
Helix pumps combine use of both high efficiency hydraulics and motors (if any).
ƒ
All metallic parts in contact with water are made of stainless steel or grey cast iron.
ƒ
For aggressive fluid, special versions exist with stainless steel only for all wetted
components.
ƒ
Helix pumps are equipped with a simple mechanical seal or with a cartridge seal to
facilitate maintenance.
ƒ
In addition, for heaviest motor, a specific coupling allows to change this seal
without removing the motor.
ƒ
Depending on the model, the pump casing is equipped with additional connections
for connecting accessories (Fig. 10).
ƒ
Helix lantern design integrates an additional ball bearing that withstand hydraulic
axial forces: this allows the pump to use a fully standard motor.
ƒ
Special handling devices are integrated in order to facilitate pump installation (Fig.
8).
7 Installation and electrical con-
nection
Installation and electrical work in compliance with any local codes and by qualified
personnel only.
WARNING
Bodily injury!
Existing regulations for the prevention of accidents must be observed.