Wills Wing Sport 2 155, Руководство по эксплуатации для владельца

Страница: 20 / 69

— 14 —
If you do have a failure of the locking hook on the lever portion, simply pop the hinge apart and
pop on a new lever part. It is also possible, though less likely, to break the forward portion of the
tip. If that happens, unthread the tip from the batten and thread in a new piece.
Once the batten is installed, in order to fit the batten tip into the trailing edge hem, you will need to
unlock the lever part of the tip and pivot it upwards. To unlock the tip, place a slight downward
pressure on the top of the lever portion of the tip, and squeeze upwards on the bottom of the lever
portion just behind the locking clasp. Then pivot the lever tip upwards. You should not feel any
resistance to the lever rotating upwards - if you do you haven't properly released the locking
portion. If you hear a click when pivoting the lever upwards, it is likely that you have broken, or
partly failed the locking tab on the lever.
After the rear of the tip has been rotated upwards, fit it into the gap in the hem of the trailing edge
and then rotate the tip downwards until it locks into place. You should hear a click at this point, and
the tip should be securely held in the locked position. (Note: A tip with a failed catch will still
"click" when you rotate the lever downwards into position, but depending on the degree of failure
of the catch, it may not support an upward load on the trailing edge sufficient to keep the tip
locked in position.)