WELS-2230 ENVY SERIES
SINGLE STATION SOLID SURFACE LAVATORY SYSTEM
INSTALLATION & OPERATION MANUAL
PAGE
9
© Rev.
3/2021
1.800.428.4065
TOLL FREE
| www.willoughby-ind.com
INSTALLATION INSTRUCTIONS
Step 1: Pedestal Mounting
Note: Wall anchoring hardware by others; use wall anchors appropriate for the wall type.
1. Unpack the Pedestal & remove the Security Screws holding the Shroud to Plate Mount Weldment.
2. Mount the 6” Z-clip to the wall as shown on the Rough-in Detail. Make sure adequate backing
exists to securely mount the Lavatory.
3.
If not yet completed, install the supply and waste rough-ins appropriate to the installation.
Refer to the Rough-in Detail for backplate access hole measurements (all by others).
4. Lift the Plate Mount Weldment & place it into the Z-clip.
5.
Level the Plate Mount Weldment, making sure that it remains flush to the wall, to mark and drill
holes for the wall anchors; the Plate Mount Weldment has (16) usable
Ø
3/8” mounting holes.
6. Re-check the Plate Mount Weldment is level front-to-back and side-to-side & secure the Pedestal
with anchors through the (16) mounting holes in the Plate Mount Weldment.
Step 2: Drain Assembly
1. Unpack the Solid Surface Lavatory, check condition.
2. Apply a small strand of plumbers putty on the
underside of the Drain Basket lip
(SEE
FIG. 1
)
.
3. Insert the Drain Basket into the Lavatory drain hole.
4. Secure the Drain Basket in place:
Fit the Rubber Washer onto the Basket from the
underside of the Lavatory, then tighten the Locknut
onto the Basket, sandwiching the Washer against the
Lavatory.
Note: Over-tightening the Locknut can damage the
Lavatory and Drain Assembly.
APPLY PUTTY
DRAIN HOLE
DRAIN BASKET
LAVATORY
LOCKNUT
RUBBER
WASHER
FIG. 1-
DRAIN INSTALLATION