WELS-2230 ENVY SERIES
SINGLE STATION SOLID SURFACE LAVATORY SYSTEM
INSTALLATION & OPERATION MANUAL
PAGE
10
© Rev.
3/2021
1.800.428.4065
TOLL FREE
| www.willoughby-ind.com
INSTALLATION INSTRUCTIONS (CONT.)
FIG. 2-
LAVATORY MOUNTING
Step 3: Solid Surface Lavatory Mounting
Note: Over-tightening assembly screws can damage the Lavatory or Pedestal Assembly.
1. With assistance, place the Solid Surface Lavatory on the Pedestal support arms
(SEE
FIG. 2
)
.
2. Align the bottom (6) Brass Inserts in the Lavatory with the corresponding through-mounting holes in
the Pedestal: (2) hole in each Pedestal support arm, (2) on the top Plate Mount Weldment rail.
3. Insert and adequately tighten the (6) Truss-head Screws into the Lavatory Brass Inserts.
Do not over-tighten
; make sure the back surface of the Lavatory remains flush to the wall.
4.
Verify that the Lavatory has remained level and flush against the wall so that water will drain
correctly once installation is complete.