WELS-2230 ENVY SERIES
SINGLE STATION SOLID SURFACE LAVATORY SYSTEM
INSTALLATION & OPERATION MANUAL
PAGE
11
© Rev.
3/2021
1.800.428.4065
TOLL FREE
| www.willoughby-ind.com
INSTALLATION INSTRUCTIONS (CONT.)
Step 4: Final Assembly
Note: Over-tightening assembly screws can damage the Lavatory or Pedestal Assembly.
1. Install the Drain Cover into the Lavatory trench drain using the included Drain Screw
(SEE
FIG. 3
)
.
2. Install faucet and any additional plumbing accessories (all provided by others; refer to accessory
manufacturers’ recommended installation instructions).
NOTE: PLUG-IN TRANSFORMER (IF NEEDED) MUST BE USED WITH A GROUND FAULT
INTERRUPT (GFCI) RECEPTACLE TO HELP PREVENT POSSIBLE ELECTRICAL SHOCK.
3. Once all plumbing has been completed and adequately tested, replace the Lavatory Shroud using
the Security Screws removed in Step 1
(SEE
FIG. 3
).
For best fit, finger-tighten the Side Screws
before finger-tightening the Front Screws; once Front Screws are in place, fully-tighten the Sides
.
FIG. 3-
MOUNT DRAIN COVER AND REPLACE SHROUD