Beer Font
Beer Line
Commercial Keg
Keg Coupler
Gas Line
CO
2
Regulator
CO
2
Gas Cylinder
Image 2
Image 3
7
6
USER MANUAL
KEGERATOR
D-Sanke Kegs
To use Sanke Kegs you will need to purchase
a D-type Coupler, Liquid D-type adapter and
a Gas D-type adapter. The Gas line connects
onto the side port of the coupler (reads
Gas In) and the beer tube connects to the
top port on the coupler. If you are putting
multiple D-Sanke kegs in the Kegerator
e.g. a 20L and 30L you will need 2 x D-type
Couplers, 2 x Liquid D-type adapters and
2 x Gas D-type adapters
For D-Sanke Kegs
INSTALLATION
INSTRUCTIONS
Setting up Your Kegerator
Watch the kegerator installation video on
www.williamswarn.com/how-to-videos
You will require 1 x Philips screwdriver
A.
Carefully remove all products from packaging.
B.
If not required remove shelf and glass rack
from the inside of the WilliamsWarn Kegerator.
C.
If you are wanting to fit the wheels now is the
best time to install them:
1.
Turn the Kegerator on its side (you may
want to put some cardboard down if
assembling on a hard surface.
2.
Screw on the wheels using the screws
provided. Two of the wheels have a brake,
these should be installed at the front of
the Kegerator (See image 1).
3.
Position Kegerator upright (do not turn on
Kegerator for 24 hours after being on its side.).
D.
Remove the fittings from the end of the Beer
font tubing. These are John Guest connections
and can be removed by pushing in the end of
the fitting and pulling the tubing out at the
same time. (See image 2).
E.
Remove the black cover and place gasket over
the hole and line it up with the 4 holes (See
image 3).
F.
Feed the tubes through the top of the Kegerator.
Using a Phillips screw driver and the 4 screws
provided screw the font in place (See image 4).
with the taps facing towards you (if you are
standing facing the door of the Kegerator). Refit
the fittings on to the end of the beer lines –
ensure they are tight by gently pulling the tubing
away from the fittings and you should be unable
to pull the tube out (Photo of installation).
G.
If you wish to mount the CO
2
cylinder on
the back of the kegerator there is a bracket
supplied that locates on the rear of the unit
(See Image 4a & 4b).
H.
Take the CO
2
cylinder and attach the gas
regulator to it. Use the spanner provided to
tighten it.
Image 1
Содержание kegerator
Страница 8: ......
