WILLIAMSWARN BrewKeg25, Руководство пользователя

Страница: 6 / 16

5
USER GUIDE
12.
Remove any pressure in the vessel by pressing
the button on the VPRV. Remove lid, sediment
bottle and drain BrewKeg25
TM
.
13.
Rinse sediment bottle in cold water thoroughly.
14.
Rinse lid in cold water and place upside down
on bench.
15.
Open butterfly valve and rinse out BrewKeg25
TM
again to remove all the detergent residue.
16.
Close butterfly valve.
17.
Fill BrewKeg25
TM
with 4L (1 gal.) of boiling water.
18.
Install lid with silicon seal properly and shake
upright, inverted and on its side for at least
10
seconds.
19.
Connect CO
2
briefly to pressurise if required
before connecting beer tap lines to flush
with remaining boiling water from inside the
BrewKeg25
TM
. (Run through beer lines until
it runs hot).
20.
Remove any pressure in the vessel by pressing
the button on the VPRV.
21.
Remove lid and place upside down on bench
before draining the BrewKeg25
TM
.
22.
Re-assemble the sediment bottle components
and attach two halves of sediment bottle together.
Fig 2: Assembled BrewKeg
TM
Lid
BEVERAGE-OUT PORT
(WITHOUT NOTCHES
ON ITS BASE HEX, WITH
TUBE EXTENDING INTO
THE VESSEL)
BREWKEG
TM
LID.
GAS-IN PORT
(WITH NOTCHES
ON ITS BASE HEX)
‘L’ IS FOR LIQUID OUT.
THE BLACK DISCONNECT
CONNECTS TO IT ‘G’ IS FOR GAS IN.
THE GREY DISCONNECT
CONNECTS TO IT
VARIABLE PRESSURE
RELIEF VALVE (VPRV)