26
Part Number 550-142-785/0812
10 Operating instructions
FOR YOUR SAFETY READ BEFORE OPERATING
If you do not follow these instructions exactly, a fire or explosion may result caus
-
ing property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition
device which automatically lights the pilot. Do
not try to light the pilot by hand.
B. Before
OPERATING, smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor. See below.
C. Use only your hand to depress or move the selector arm. Never use tools.
If the selector arm will not depress or move by hand, don’t try to repair it,
call a qualified service technician. Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately
call a qualified service technician to inspect the appliance and to replace
any part of the control system and any gas control, which has been under
water.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire depart
-
ment.
WhAT TO DO IF YOU SMEll GAS
1. STOP
! Read the safety information above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove jacket front panel.
5. This appliance is equipped with an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
6. Turn
Gas control knob
clockwise
to OFF.
7. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas,
STOP
! Follow “B” in the safety information above. If you don’t smell
gas, go to the next step.
8. Turn
Gas control knob
counterclockwise
to ON.
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the instructions “
TO TURN OFF GAS TO AP-
PLIANCE” below and call your service technician or gas supplier.
12. Replace jacket front panel.
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO ThE APPlIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
3. Remove jacket front panel.
4. Turn
Gas control knob
clockwise
to OFF. Do not
force.
5. Replace jacket front panel.
GWI
Series 2
Gas-Fired Water Boilers –
Boiler Manual
