Williams-Sonoma CARBON8, Руководство пользователя

Страница: 4 / 7

User Guide
6 7
User Guide
SETUP AND INSTALL
THE CO2 CYLINDER
Set the Carbon8 onto the rubber drip mat and Plug the power cord into a
grounded mains socket with a rated voltage of 110V / 60Hz. Make sure the Touch Button light is on.
Remove the magnetic Drip Tray and the CO
2
cover.
Remove the seal and the cover from the Carbon8 CO
2
cylinder.
Push the cylinder up and screw it clockwise while applying pressure until it is firmly held in place.
Tilt it back into the body of the Sparkling Water Maker. Hand-tighten only; DO NOT use tools.
Re-attach the cover by fitting the tab at the top of the cover into the slot on top. Push gently the
cover into place. Finally, put the Drip Tray back into place.
When you need to replace the gas cylinder, remove the tray and cover. Grab the bottom of the
cylinder with your index finger and thumb and tilt the cylinder out. Unscrew it counterclockwise
and then carefully pull it out of the compartment.
1.
2.
3.
4.
1. 2. 3. 5. 4. 6.
5.
6.
Fill the
Water tank
When re-inserted correctly, there is no gap between the bottom
of the tank and the base. Do not carbonate if the tank is not
resting on the base.
Even though Carbon8 works with room temperature water, cold
water carbonates better. Add some ice into the tank or keep the
water tank in the fridge, so you have one ready to carbonate.
Before the first use, rinse the water tank with lukewarm
water. Alternatively, you can use a soft cleaning sponge (or
cloth) and a non-irritating detergent to clean the water tank.
Open the cover and fill the water tank with cold, clean water
up to the marked filling line.
WARNING! Do not carbonate anything other than water. Other
liquids can contaminate and clog the internal parts,
potentially resulting in excessive pressure and serious injury.
To remove the water tank for filling or refrigerated storing,
push the tank back and up.
The Snap-Lock will release the tank, and you can lift it
vertically up.
1.
2.
3.
4.
5.
NOTE: PRO TIP: