Will Burt NIGHT SCAN VERTICAL, Руководство по эксплуатации

Страница: 60 / 100

PAGE 58 OF 98
NIGHT SCAN VERTICAL
OPERATING INSTRUCTIONS
TP-4836201-G
MARCH 2021
cold weather use, but is also suitable for year-round use. Regular winter maintenance and
frequent use of TMD Mast Lubricant should significantly reduce the potential for mast freeze-ups.
To clean and lubricate the mast:
1. Have one person press the "Mast Up" button to slowly pressurize the mast just enough to
extend the desired mast section. A second person may have to hold down the larger mast
section collars to ensure the desired tube extends. Release "Mast Up" button as soon as the
desired mast section is fully exposed.
2. Wipe down the desired mast section using a non-abrasive cleanser or solvent, such as
lacquer thinner. Do not allow the cleaning fluid or solvent to run down inside the collar.
3. Inject approximately ½ oz. of TMD Mast Lubricant or lightweight machine oil into the weep
hole (drain) of the exposed mast section. The weep holes are located approximately 10"
below the collar on each tube except the top tube.
4. Repeat steps 1-3 for the next larger mast section. Do not lubricate the exterior of the mast.
This will cause the lubricant to attract dust and contaminants from the air.
5. Using the "Mast Down" button, lower the mast.
6. Wait several minutes to allow the lubricant to settle and spread around the wear ring and seal
at the bottom of each mast section.
7. Using the "Mast Up" button, extend the mast one section at a time. For each section, wipe off
any excess lubricant that flows out the weep holes.
7.3 Spare Parts
To order spare or replacement parts, always refer to the mast model number and serial number.
The model number, serial number, and additional information is located on the mast Identification
Plate on the mast base. To order spare parts, contact The Will-Burt Company.
7.4 Periodic Inspections
This section describes the systematic care and inspection of equipment to keep it in safe
operating condition and to prevent breakdowns. If the system does not perform as required, see
Section 9 for troubleshooting. If anything looks wrong and cannot be diagnosed and/or fixed,
contact The Will-Burt Company. Table 7-1 provides a schedule of periodic inspections and
procedures required to keep the Mast System in safe operating condition.