Wilfa PSI-1800, Инструкция по эксплуатации

Страница: 55 / 62

7
English
P.
Filling with water
Make sure that both the Steam Control Knob and Temperature Control Dial
are in the “OFF” position.
Hold the iron upright so that the water-fi lling inlet is in a horizontal position.
Fill with water through Water Filling Inlet until the water reaches the “MAX”
mark indicated on the side of the iron, and never fi ll above this mark.
Note: Because of the soleplate design, ordinary
tap water may be used with this iron. However,
in very hard water areas, we recommend using
distilled or demineralized water.
Operating instruction
Turn the temperature control dial to the desired fabric/temperature setting.
Place the iron on its heel (on a stable, protected surface) while the iron is
warming to desired temperature, approximately two minutes.
1
2
1
STEAM Function button
When the LED lamp turn green, Pressing the steam button and hold
at upright provides pressurised steam which aids in removing stubborn
wrinkles from fabrics such as denim, cotton or linen.
2
SPRAY BUTTON
Pressing this button and holding provides a defi ned jet of spray which
gently moistens fabric. It is useful on fabrics with stubborn wrinkles.
3
VARIABLE STEAM CONTROL
Set the temperature to
••
,
•••
dots or Max. The LED lamp will turn
red, heating up until the LED lamp turns green. Pressing the steam
button
one time will cause steam to be emitted from the soleplate.