LEDs of the bases
!
• LED blinks purple when a base is rebooting
• LED blinks red when a base reports a configuration error
• LED remains solid blue if a base is configured and registered to the Wildix PBX
!
Configure the cordless phone
!
• switch on your phone and wait till the system assigns you an “unknown account” and the
coverage indicator turns active
• dial “99”
• enter an extension number configured on the WMS and a user password
!
The phones can be registered manually
(e.g. if a phone belongs to another network)
!
• Verify that there is only one active W-AIR Network
• Go to the main menu
• Select Connectivity
• Select Deregister, enter 0000 as PIN, then press Yes
• Select Register, enter 0000 as Access code, then press OK
• The cordless phone is ready for a new login procedure
!
Notes:
• you can assign a new user any time you need by repeating the login procedure
• Currently after this operation you should turn off the phone and then turn it on again for the
gateway to activate a new account.
• Currently the base can reboot at any login/logout.
• Currently in order to perform a login/logout on a phone connected to a Slave gateway, at least a
phone should be connected to the Master gateway.
• Currently the shared phonebook can load up to 200 contacts.
!
!
Set up Repeaters
!
• find the IP of the base station that you want to repeat (on the WMS devices list)
• access the http interface from your browser, enter a username “admin” and a password
“wildix”
• select
Repeaters
in the menu and click on
Add Repeater
• select
Manually
from the drop-down menu if it is present, then choose the Station ID (
DECT
sync source
) where you want to connect the Repeater and confirm by pressing the Save
button
• remove the power cable from the Base station
(PoE) and after the system reboots, go back
to the http interface of the Base station
W-AIR Administrator’s Manual
10
