Notes:
• If you have any problems with registering Repeater(s) you can reset it by pressing the Reset
button on the back side. While the Repeater is off, turn on the repeater, LED becomes solid
RED and then GREEN with a double pulsation. You can start the registration procedure
again by following the last three points above.
• The Repeater should be placed on a distance not less than 10 meters from its Base station.
• For a good conversation and a correct handover between bases and Repeaters the dBm value
should be between -75 and 0. (See the chapter 2.2. Check the Radio Coverage - Repeaters)
LEDs of the Repeaters
• LED blinks green with a double pulse during the first registration process
• LED blinks green during the connection process
• LED remains solid green when it is registered to a base station
• LED blinks green with a fast pulse when a phone connected to the Repeater starts a new
call, during the conversation it blinks red
• LED becomes solid red if the Repeater fails to connect to the base station
4. W-AIR Network installation analysis (W-AIR Base
Station Multicell)
Look at the DECT Chain Tree to check the solution you have decided to set up.
The DECT Chain Tree should correspond to the real Bases deployment (as in the following
example)
The value shown in the “DECT sync source” field indicates the real dBm value.
Based on this value you can choose the best connection solution for your system, taking into
consideration any obstacles present in the environment.
Wildix W-AIR System - Administrator’s Manual 3.80.x
13
