Power Save
Power On
Setting Time
Test Mode
1.
Check the battery level icon to ensure
the batteries just installed contain the
proper charge level. If so, you are ok to
proceed with camera use.
2.
To turn the unit ON press and release
the power button.
1.
To change date and time, start by
pressing and release the center
navigation button to set the hour.
2.
Press the left or right navigation
button to go up or down in sequence.
3.
When the hour is set, repeat steps 1
and 2 to set the minutes.
POWER
POWER
POWER
Ready
Time/Date
Location
Trigger
Flextime
PIR Active
Delay
PIR Mode Flextime
P1 P2 Interval
24Hr Day Night
30sec 1min 2min 5min
POWER
POWER
Ready
Time/Date
Location
Trigger
Flextime
PIR Active
Delay
PIR Mode Flextime
P1 P2 Interval
24Hr Day Night
30sec 1min 2min 5min
page 5
page 6
NOTE: LCD cycle through camera
information. PIR picture number >
Flextime number > Remaining
pictures > Time
After 30 seconds without any buttons
being pushed, the LCD will turn off and
camera enters into Power Save or
Ready Mode.
1.
The LCD screen can be awakened by
pressing the Power button briefly.
Note: The LCD will not “wake up” when
camera is writing to memory.
2.
PIR LED Status Light: During the first
2 minutes of Ready Mode, the red light
will illuminate when a PIR event is
triggered. The red light will blink for
2-3 seconds when photo is taken
during this first 2 minutes. After 2
minutes all indicator lights will turn
off until a button is pressed.
1.
LCD Ready Mode: The camera will
automatically enter Ready Mode if a
button is not pressed for greater than
30 seconds. The status lights will
illuminate for a total of 2 minutes.
2.