Now, cut off the head of the stud/screw and thread the rest of the hardware onto the screw.
Here’s a tip. When you cut the head off with your Dremel, it will be hot. Don’t let it fall on
your legs or on the surface or it will burn through the covering (or your skin or pants).
Rudder tiller;
After the upper hardpoint has been drilled through with a 9/64 drill, install the tiller bar so
that it is showing the same amount of threads on each side of the rudder. Once the stud is
installed cut the head off with your Dremel.
After the tiller bar is installed, if you need to adjust the position you can do this without
damaging it by double-nutting two 8-32 nuts and use a wrench to turn the stud into the hard-
point.
Now install the horns exactly the same distance from the rudder surface. If using the DuBro
horn set for this you should re-drill the horn with a 1/8” bit in a location that is even with the
hinge center line/ Both horns should be drilled at the same point. Then trim the excess from
the horn leaving at least 1/8” of material at the end.
