widos RSR 630, Перевод инструкций по эксплуатации

Страница: 22 / 27

Kunststoffschweißtechnik
WIDOS Einsteinstr. 5 Phone ++49 (0)7152 / 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax ++49 (0)7152 / 9939 - 40
www.widos.de email: info@widos.de
29.03.2011 Working instructions WIDOS RSR 630 Page 22 of 27
6. Maintenance / storage / transport
Goal of the chapter is:
•
Keeping the nominal state and the operation capacity of the machine.
•
Efficient planning of the maintenance work and the maintenance tools.
•
Increasing the efficiency by avoiding non-planned outage.
6.1. In general
All maintenance and repair work has to be basically performed with the machine in
off position.
During this, the machine has to be secured against unauthorized switching on.
Prescribed maintenance and inspection work should be performed in time.
We recommend inspection work after 1 year.
For machines with a specially high usage percentage the testing cycle should be
shortened.
The work should be performed at the WIDOS GmbH company or by an authorized
partner.
The linear guides must be cleaned every week e.g. with a brush.
Check the linear guide carriages every 3 months and grease them over the
lubricating nipple if necessary.
Chips or other impurities in the guides can be the cause if the swiveling plate jams
or runs heavily.
•
The operating staff has to be informed before the starting of the maintenance work.
•
Check the tightness of all screwed connections every three months .
•
Replace damaged parts immediately. Be particularly careful with electric parts → dust and
humidity are very much current leading.
•
Only use original WIDOS spare parts for repair work.
•
Store dry.
•
Protect the machine from heavy shocks.
•
Handle the machine carefully.
•
We recommend basically to remove regularly any remaining cutting chips (switch off the
machine!). For that purpose, unscrew the cover (chapter 6.3).
6.2. Storage
If any storage becomes necessary, make sure that the storage room is dry and that the
temperature is b5° C and +35° C.
6.3. How to remove the cutting chips from the saw arm
Remove regularly any remaining cutting chips from the saw arm.
For that purpose unplug the saw.
Open the doors of the saw arm.
Remove the cuttings by vacuum. Close the housing again.