Kunststoffschweißtechnik
Starting and operating
Chapter 5
29.03.2011
Working instructions WIDOS RSR 630
Page 21 of 27
5.3. How to cut radiuses
Carefully swivel the assembled prism without clamped-in pipe to the saw blade
and check that the saw blade does not touch the prism during cutting!
•
Firmly clamp the pipe (chapter:
Fehler! Verweisquelle konnte nicht gefunden werden.
)
and activate the optional vacuum device.
•
Press the button at the handle (no. 3) by the left hand in order to
start
the saw motor.
•
Grab the lever (no. 4) by the right hand and move the swiveling device with adequate speed
in order to cut the radius.
As soon as the pipe has been
cut, the remaining piece of the
cut pipe drops down in the rear
area!
5.4. How to cut angled radiuses
After the prism has been assembled, please carry out a swivel check
without clamped-in pipe in order to check that the saw blade does not
touch the prism!
•
Fix the pipe tightly (chapter:
Fehler! Verweisquelle konnte nicht gefunden werden.
) and
activate the optional vacuum device.
•
Press the button at the handle (no. 3) by the left hand in order to
start
the saw motor.
Grab the lever (no. 4) by the right hand and move the swiveling device with adequate speed
in order to cut the radius.
As soon as the pipe has been cut, the remaining piece of the
cut pipe drops down in the rear area!
Handle with button (no. 3)
Lever (no. 4)
