Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen
Fax
+49 (0) 71 52 99 39 - 40
Website:
www.widos.de
Email:
25.03.2014
Working Instructions WIDOS ASM 315 WM
Page 29 von 45
7. Maintenance / Storing / Transport
7.1. General
Replace damaged parts immediately, be particularly cautious with electrical parts - dirt and
wetness are very good current conductors.
Only use original
WIDOS spare parts
.
Check the tightness of all screwed connections
every three months
and tighten the screws
when needed.
All maintenance and repair works have to be basically performed with the machine
in off position.
During this the machine has to be secured against unauthorized activation.
Prescribed maintenance and inspection works should be performed in time. The
DVS gives the advice of inspection works after 1 year.
For machines with especially high usage percentage the testing cycle should be
shortened .
The works should be performed at the WIDOS GmbH company or by an
authorized partner.
The guide shafts and threaded spindles must be cleaned every week e.g. with a
brush and grease them when needed.
The linear guides must be cleaned
every week
, e.g. with a brush.
Check the linear guide carriages
every
3 months
and grease them over the
lubricating nipple if necessary.
Dirty guides may cramp and run heavily.
7.2. Clamping
elements
For a long service life clean and grease regularly the threaded spindles and the joint parts
which are used for clamping the pipes.
7.3. How to clean the machine
The used materials and tissues are to be handled and disposed of properly, especially:
when cleaning with solvents
when lubricating with oil and grease.
