widos 7000 WM, Перевод инструкций по эксплуатации

Страница: 49 / 110

Ku nst sto ffschweißtec hni k
Welding process Chapter 6
25.11.11 Working Instructions WIDOS 7000 WM page 49 of 98
Display:
2nd line:
heat up
T=210°C Pi=0
Display of:
heating element temperature and actual pressure
Activate table limitation with <switch 16,
>
, the switch illuminates.
At the end of the heating time, the button <Enter> flashes and a beeping
sound can be heard.
6.2.7. Change over
Press button <Enter>.
Open tables up to limitation, <joystick 13> on:
, the heating element
detaches from both pipe ends.
Move heating element out of the machine quickly, <joystick 5> on:
.
Close basic machine again within the change over time, <joystick 13>
on:
.
Display:
2nd line:
change over
t=4s Pi=0
Display of: Remaining change over time and
actual pressure
6.2.8. Pressure ramp
Constantly raise pressure within the prescribed pressure built-up time up
to nominal pressure. Hold the <Control lever 13> just for about 10 s on:
in order that the hydraulic accumulator may fill up.
Display:
2nd line:
ramp
t=2s Pi=6
Display of:
Heating element temperature and actual pressure
6.2.9. Joining / Cooling
Adjust the joining pressure with <pressure controller 14> until nominal
pressure = actual pressure.
Display:
2nd line:
cooling
t=3:32 Pi=12
Remaining cooling time (minutes) and actual
pressure
alternating with:
Display:
2nd line:
cooling
Ps=12 Pi=12
Comparison nominal and actual pressure
In case of decreased pressure during cooling time, a beeping sound can
be heard. Readjust pressure to nominal pressure.