widos 7000 WM, Перевод инструкций по эксплуатации

Страница: 19 / 110

Ku nst sto ffschweißtec hni k
Operating and indicating elements Chapter 4
25.11.11 Working Instructions WIDOS 7000 WM page 19 of 98
No. Denomination Function
9 Joystick (cylinder 4) right
clamping tool
- To open right clamping tool
- To close right clamping tool
- To clamp right clamping tool (option)
-
To release right clamping tool (option)
10 Joystick (cylinder 3)
clamping tool (Option)
- To open clamping tool
- To close clamping tool
- To clamp clamping tool (option)
- To release clamping tool (option)
11 Pressure gauge - Pressure indication [bar]
12 Pressure controller
-
Adjust bead-up pressure (Reading: on pressure gauge)
13 Joystick tables
-
To close tables for bead-up
-
To open tables
-
To close tables for joining / cooling
-
To close tables for planing
14 Pressure controller
-
Adjust welding pressure (Reading: on pressure gauge)
15 Pressure controller - Adjust planing pressure (Reading: on pressure gauge)
16 Switch: change over
limitation
-
on: change over limitation , switch illuminates
-
off: change over limitation , switch extinguishes
17 Button: pressure release
- for heat-up, after reaching revolving bead-up height
- to unclamp welding piece at the end of the welding
process
-
to relieve pressure limitedly on preset value only
upon activation of <joystick 12>
Example: In case you intend to carry out welding with two different cooling pressures,
you may:
-
use the aligning pressure as first cooling pressure, for this purpose you must put the
<joystick 12> on: after the change-over.
-
You must put the <joystick 12> on for a minor (preset) cooling pressure and
simultaneously press .