Wido WD012411400, Руководство пользователя

Страница: 10 / 16

1400W MIXER ENG
OPERATING INSTRUCTIONS
Note: Before using the power tool, read the instruction manual carefully.
1. Intended use
The machine is intended for mixing pulverized building materials such as mortar, plaster, adhesives, as
well as solvent free paint, varnish and similar substances.
2. Before using your power tool
1)
1)
2)
Selection of the mixing paddle is dependent on the material that is to be mixed.
2) Ensure that the power switch is in the off position. If the plug is connected to a power receptacle
while the power switch is in the on position, this power tool will start operating immediately, inviting
serious accident.
3. Installing the mixing paddle
The power tool is supplied with a two piece mixing paddle. The two pieces of the mixing paddle
simply screw together (See Fig 1) and should be securely tightened using the spanner supplied.
The mixing paddle should be screwed into the power tool spindle and securely tightened (See Fig 2).
Warning: Before installing tool, remove mains plug from mains supply.
4. Operating the on/off switch
1) To start the power tool, simply depress the switch trigger. Release the switch trigger to stop your
power tool.
2) If you wish to use the power tool continuously, depress switch trigger then lock on button, release
switch trigger first and lock on button second (See Fig 3). Your switch is now locked on for continuous
use. To turn off your power tool just depress and release the switch trigger. The switch will return to "off"
position automatically.
Note:
This power tool is equipped with electric soft-starter and it shall be started slowly without a
sudden impact when power tool is switched on.
5. Variable speed control
Adjust the variable speed control to increase or decrease the speed according to the material and
accessory to be used. Turn the variable speed control in anticlockwise direction to increase speed and
in clockwise direction to decrease speed (See Fig 4). High speed gives higher torque and low speed
will provide low torque.
Warning: Do not operate for long periods at low speed because excess heat will be
produced internally.
6. Two speed control
Choose position “
1
” for high torque and low speed range for mixing heavy materials. Choose position
“ 2 ” for low torque and high speed range for mixing light materials (See Fig 5). If the gears do not
engage easily, rotate the spindle by spanner to align the gears. Never change the gears when the tool is
rotating, wait until it has stopped.
10