Wido WD012411400, Руководство пользователя

Страница: 11 / 16

1400W MIXER ENG
7. Operation
Position the mixing container on a horizontal, stable and secure surface.
Place the materials to be mixed in the mixing container in accordance with the recommendations
provided by the manufacturer of the materials.
3) Check the mixer and particularly the security of the attached mixing paddle.
4) Place the mixing paddle in the mixing container.
5) Adopt a secure stance holding the mixer with both hands.
6) Choose two speed position by two speed control and with the lowest speed setting selected
depress the trigger. Switch to start the motor slowly.
7) Be prepared for the impact of the torque forces especially on start up.
8) Adjust the speed of the motor to give optimum mixing performance.
9) During mixing, guide the mixing paddle around the mixing container
(See Fig 6) .
10) Continue mixing until the required material consistency is achieved.
11) Release the switch trigger and allow the mixing paddle to come to a complete stop.
12) Remove the mixing paddle from the mixing container.
Warning: If the mixing paddle comes into contact with the bottom or side(s) of the mixing
container during mixing operations ‘kick back’ can be experienced.
WORKING HINTS FOR YOUR POWER TOOL
1. When using this power tool for mixing liquid, or dry powdered or granulated materials, follow
material manufacturer instructions and precautions.
• Do not run the power tool on a stand.
• Avoid splashing around the material being stirred to prevent slipping and losing control over the power
tool.
• Avoid prolonged use of the power tool at lower speeds. Otherwise the motor of the power tool could
overheat.
2. Selection of the stirrer paddle is dependent on the material that is to be stirred.
3. For materials with low viscosity, e. g. emulsion paint, varnishes, adhesive, grouting compound,
cement slurry, use a stirrer paddle with a left hand spiral. The material is moved from the top
downwards in a stirrer paddle with a left-hand spiral. The stirrer paddle is pushed upwards. Materials
with low viscosity are mixed in a way which minimizes splattering.
4. For materials with high viscosity, e. g. plaster, concrete, cement, screed, filler, epoxy resin, use a
stirrer paddle with right-hand spiral. The material is moved from the bottom upwards in a stirrer paddle
with a right-hand spiral. The stirrer paddle works its way into the mixture. Materials with high viscosity
are mixed thoroughly.
5. While mixing, move the power tool in an up and down motion. Clean the stirrer paddle after use.
MAINTENANCE
Warning: Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
1. Keep the power tool ventilation slots clean and free from obstructions. If available, blow compressed
air into the vents to clear any internal dust (safety goggles must be worn when undertaking this
process).
2. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth.
3. Your power tool requires no additional lubrication.
11
1)
2)