Customer helpline number: 01604 633607
5
Step-by-Step Installation Instructions for
Sliding Door (217-005)
7.
Drill the 8 marked locations with a 6mm masonry drill bit
Fig.6
. for a wall plugs.
8.
Insert the wall plug into the drilled hole, using the rubber mallet, ensuring a fl ush fi tting with
the wall surface.
Fig.7
.
9.
Carefully replace the assembled shower screen back into position, lining-up the slotted
holes of the end channel with the inserted wall plugs and loosely fi t screws and screw cap
washers, allowing the frame to be moved if needed.
10.
With the frame centralised between the two end channels, check vertical alignment of the
channel, using a spirit level. When correct, gently tighten the two top and bottom screws
and re-check alignment – if OK, tighten all screws fully (if not re-align and tighten) – repeat
for the other side. Next: The frame assembly (without doors) should now be secured to the
end channels (which are fi xed to the wall).
Fig.8
.
11.
Making sure that the panel assembly is central between the end channels, check levels of
frame assembly and adjust if necessary. From inside the enclosure, mark the positions of
the side panel assembled frame against the end channel.
12.
When correct, drill fi xing holes into the frame - inside wall only - (3 per side), using a 3mm
metal drill bit
Fig.9
.
13.
Pre-assemble the 10mm-screw with screw-cap washers.
7
8
9
4
5
6
8892_Step_By_Step_Sliding Door_V3.indd 5
8892_Step_By_Step_Sliding Door_V3.indd 5
1/9/10 17:54:02
1/9/10 17:54:02
