15
Descriptions of LEDs and buttons:
1.
Red LED:
Ice Full indicator light.
When this LED is lit, the ice storage bin is full of ice or there is something between the two
arms of the ice-full sensor in the ice storage bin. The unit will stop working. When ice cubes
are taken out of the ice storage bin, clearing the sensor, the red LED will keep flashing for 3
minutes. Then the unit will restart and return to the ice making mode.
2.
Green LED:
Ice making indicator light.
When this LED is lit, the unit is working in the Ice Making mode controlled by a temperature
probe on the evaporator. When the green LED is flashing, the unit is working in the Ice
Making mode controlled by a fixed timer.
3.
Yellow LED:
Ice Harvest indicator light.
When this LED is lit, the unit is working in the Ice Harvest mode controlled by a temperature
probe on the evaporator. When the yellow LED is flashing, the unit is working in the Ice
Harvest mode controlled by a fixed timer.
4.
Clean button:
When this button is pressed, the unit enters the Cleaning mode. The green and yellow
LEDs flash together. To stop the Cleaning mode, just press the button again.
5.
Mode button:
Mainly for service.
When this button is pressed, unit can change from Ice Making mode to Ice Harvest mode or
from Ice Harvest mode to Ice Making mode.
6.
Ice Size Adjustment Guide:
1.) Press and hold the “
Clean
” button and the “
Mode
” button together for at least 3 seconds. The
unit will enter the Ice Size Adjustment mode. The “
ICE Making
” LED (green) will be blinking
continuously during the ice size adjustment.
2.) While in the Ice Size Adjustment mode, press th
e “
Clean
” button or the “
Mode
” button for the
desired ice size.
Smaller ice setting:
By pressing the “Clean” button, you can decrease the size of the ice cubes. The “ICE FULL” LED (red)
will flash as you lower the ice size and will finally be blinking at the setting of smallest ice size.
Larger ice setting:
By pressing the “Mode” button, you can increase the size of the ice cubes. The “ICE HARVEST” LED
(yellow) will flash as the larger size is set and will blink when the setting of largest ice size has been
reached.
After 10 seconds without any operation, the unit will automatically memorize the current state
and return to the previous mode.
NO
TE: If during the ice size adjustment, the “ICE FULL”, “ICE MAKING” and “ICE HARVEST” LEDS
blink all at once, this indicates that the unit is in the default factory setting of the ice size adjustment.
